Planarity Measurement for Metal Plates

QuellTech GmbH
Favorites

Successful switching from offline testing to 100% inline testing of flatness

Initial Situation

The planarity of surfaces of mechanical components must be checked. There are tolerances of less than 15 microns for the planarity specified. So far, the flatness has been measured with tactile CMM system. This is a time-consuming process that can only be performed on a random basis.

Particular Challenges

The measurement data of the parts were previously recorded using a tactile measurement method (CMM system). To upgrade the system to a 100% inline test system, a QuellTech high-resolution, high-scan-speed Laser Scanner was intended to be used. In order to use this laser-assisted test process in a production with a 100% in-line test, several challenges had to be mastered: the ambitious cycle time had to be maintained, the flatness values should be comparable to the tactile recorded values. It had to be taken into account that a tactile stylus tip has significantly larger dimensions than a laser line. As a result, the values measured with lasers assume significantly higher values than the tactile measured values. Furthermore, areas of the edges of the surface had to be specially treated, since there were unwanted reflections, which falsified the measurement result.

QuellTech Solution

The advantage of the QuellTech Laser Scanner is its high resolution and the possibility to record point clouds at high scanning rates. In addition, it is able to output a nearly reflection-free 3D point cloud. Over 12 million points were recorded within a few seconds in this application. The precision of the measurement was a few thousandths of a millimeter. The software can be parameterized to such an extent that the planarity value measured with the laser scanner corresponds approximately to the tactilely measured value. The edge areas of the test area were subjected to a separate test.

Benefits for the Client:

The high-resolution QuellTech Laser Scanner Q6-C15-45 has proved to be an important tool for the customer in switching from offline testing to 100% inline testing of flatness. Thus, the quality of the final product could be improved and costly rework on the machine could be minimized.

QuellTech GmbH

Leonrodstrasse 56

80636 München

Germany

Contact: Stefan Ringwald

Phone: +49 89 12472375

Email: SRingwald@quelltech.de

Web: http://www.quelltech.de/

Planarity Measurement for Metal Plates
Planarity Measurement for Metal Plates

Planarity Measurement for Metal Plates

Planarity Measurement for Metal Plates

Planarity Measurement for Metal Plates

Planarity Measurement for Metal Plates

Planarity Measurement for Metal Plates

Planarity Measurement for Metal Plates

Planarity Measurement for Metal Plates

Products associated

Associated projects